Check: The Best Ryobi Replacement Battery You Can Buy Now
Before planning on rebuilding your Ryobi battery, here are a few things you ought to consider:
The dangers when doing the procedureSince it is considered to be a power tool battery, a Ryobi cell can produce up to 18 volts. A battery with high voltage capacity can be dangerous since it can leak poisonous fluids or explode if not handled properly.
The compatibility of new and old cellsA Ryobi 18v battery has extreme charge and discharge capacities. If you plan to replace these with cells having lower charge and discharge rates, it will result to overheating, explosion, or cell leakage. Also, other tools don’t seem to reach a full charging capacity with incompatible battery packs.
If you are interested in Ryobi battery compatibility, click the link to read.
The versatility of your chargerYou need to make sure that your charger can function well with new batteries. In most cases, they do, but you ought to make sure that it won’t take too much time and that a full capacity is achieved after every charging.
Here are the steps to do so:
Prepare the toolsYou will be needing a wire cutter, screwdriver, solder, and soldering iron. You can also prepare a hot melt glue and a tape which you can use to put the batteries together.
By doing this, you need to unscrew six bolts at the bottom. After that, you gently yank the orange and black sections apart from each other.
Determine the cells you haveAs you put the batteries together, it is advisable to solder the ends of each battery to ensure that positive ends are directly connected to the center of negative ends. You can also use hot melt glue or tapes to firmly keep the batteries together. After securing your battery pack, you attach the thermistor to one of the cells. Assemble the black and orange covers again by putting back the screws.
Inspect and redoYou have to make sure that the entire procedure gives off good results. You can use high-end battery testers, or you can simply use your Ryobi battery in one of its tools. If your tools work, then it is a job well done. If not, you can simply troubleshoot other factors and do it all over again.